Posted by PARTSMASTER on November 22, 1998 at 18:10:07:
In Reply to: Cam swap for Vortec 350 posted by David on November 22, 1998 at 02:28:35:
: Hi I wanted to know if You can put a cam from the zz4 motor or the hot cam into the vortec 350? If so, do you need to change the valve springs out? Also do you know if Edelbrock is going to make there pro flow sys. for a Vortec motor the same one as the 3500. Thanks for any info..
: Dave
Vortec valve springs are good for around .470 lift. Yes you can put these camshafts in with a valve spring change. The new Edelbrock system will be based on the TBI conversion not the 3500.Similar to #3501.