Chevrolet and GM Performance Parts - 4.00” Bore Cast Iron Racing Bow Tie Bare Block

Chevrolet - 4.00” BORE CAST IRON RACING BOW TIE BARE BLOCK

This block is “CNC” machined from a raw casting P/N 10051184. All traditional racing modifications are provided by the factory.

Featuring Chevrolet and GM Performance Parts.

Key - gmblock

CLEARANCE
FRAMES
Updated 09-08-2004.

WEB SITE NAVIGATION

GM & SC
HOLLEY
AFR

EDELBROCK
FLUIDAMPR
R&M

SCAT
MSD

DEMON
WORLD

HUGHES
TREMEC

RICHMOND
PROFORM

BOW TIE SMALL-BLOCK BARE BLOCK NAVIGATION

Street 10051181	Street 10051183	Amateur Comp. 10185047	Sportsman 12480047	Sportsman 12480049
Racing 24502501	Racing 24502503	Racing 24502525	SB2 / SB2.2 24502600	Racing 24502650
We have more GM Blocks available.

DESCRIPTION

4.00 Inch Bore Cast Iron Racing Bow Tie Bare Block

Bow Tie 4.00" Bore Cast Iron
Racing Bare Block

P/N 24502503
This block is “CNC” machined from a raw casting P/N 10051184. All traditional racing modifications are provided by the factory. The heart of this block starts with a siamesed bore cylinder case at a 3.995” bore, but can be bored to 4.155”. This case is then blueprinted on the cylinder decks (9.025” deck height), front of case, rear of case, and oil pan rail surfaces as well as the head dowel locator pin locations. In addition all galleries required for dry sump oil system operation are drilled and tapped for pipe. 8620 steel bearing caps are installed on all locations on the block. The intermediate main bearing caps have the outer 7/16” diameter studs installed at a 20° splay, while the front bearing cap has 7/16” diameter studs on the inner locations and 3/8” diameter straight bolts on the outer locations. The rear bearing cap is a two-stud (7/16” dia.) configuration and utilizes a two-piece rear seal design. After installation of the steel bearing caps, the block is align bored. Use cam bearing kit P/N 12370843 only.
Technical Notes: The above bore sizes are after honing .005” from the cylinder by a professional engine builder. Special features are: Priority main oiling; Bearing cap inner bolts spread .210 to allow use of “2.65” dia. journal cranks on properly modified blocks; Sonic bore check (data provided); Enlarged cam bosses front and rear to allow use of larger bearings; Enlarged lifter bosses; Early model two-piece rear main seals; Uses pre-1986 oil pans; and Uses premium quality studs and 8620 20° steel splayed main bearing caps.

SPECIFICATIONS:

Block Material:
Cylinder Wall Type:
Cylinder Deck Height:
Cylinder Bore Range:
No. Bearing Cap Bolts:
Cap Bolt Orientation:
Bearing Cap Type:

Cast Iron
Siamesed
9.025”
3.995”-4.155
4
Splayed 20°
8620 Steel

Crankshaft Journal Dia.:
Oil Sump Type:
Crankshaft Seal Type:
Design Max. Stroke:
Weight (lbs. - bare):
Intended Max. Hp @ RPM:
Intended Usage:

2.45”
Wet
2 piece
3.75”
183
700 @ 8500
Professional Compitition